Hold Down Bars are sized at the factory to fit the duct bank being installed. Depending upon the configuration, the Hold Down Bar is typically supplied to accommodate either one or two pieces of rebar…
Read More
2C
2″ Duct Donut Spacer with 1-1/2″ or 3″ duct-to-duct separation With the Duct Donut Spacer you can save time and effort. Your duct bank can be easily pre-assembled outside of the trench. You can also…
Read More
Push Nut
Rebar PUSH NUT securing a HOLD DOWN BAR. PUSH NUTS are available for #3 (3/8″) and #4 (1/2″) rebar. The Hold Down Bar is a simple, inexpensive, reliable device that prevents duct flotation during and…
Read More
Push Nut Tool
PUSH NUT TOOL (UDI Part No. HTL-9572) shown with a PUSH NUT ready to be installed on a length of rebar. The Hold Down Bar is a simple, inexpensive, reliable device that prevents duct flotation…
Read More
626W30-2
Special Duct Spacer to accommodate 2 ea. 6″ & 1 ea. 2″ Conduits with 3″ Duct-to-Duct Separation. The Wunpeece Duct Spacer allows for the fastest and sturdiest installation for concrete encased duct runs. With the…
Read More
646W20-3
Special Duct Spacer to accommodate 2 ea. 6″ & 1 ea. 4″ Conduits with 2″ Duct-to-Duct Separation. The Wunpeece Duct Spacer allows for the fastest and sturdiest installation for concrete encased duct runs. With the…
Read More